AP330 and AP350 Hardware User Guide

Read about and view specifications for the AP330 and AP350 in this topic. Install the AP330 or AP350 using this topic.

Country Code

If your access point is configured for the World Regulatory Domain, it is important to set the country code to the country in which the AP will be deployed to meet regulatory requirements and for optimal wireless operation. To do this, follow these steps:

  • The country code selection is for World models only and is not available to FCC, CAN, and other country-specific models. Per FCC regulations, all Wi-Fi products marketed in the United States must be set to U.S. channels only.

For Devices Running HiveManager

  1. Power on the AP and allow it to find and connect to ExtremeCloud IQ. Once the AP is connected it appears in the table of devices on the Manage > Devices page.
  2. Select the check box next to the AP, and then choose Assign Country Code from the Actions drop-down list. In the dialog box, select the appropriate country from the drop-down list, and then click Save.
  3. Upload your changes to the device.

For Devices Running HiveManager Classic

  1. Power on the AP and allow it to find and connect to HM Classic. Once the AP is connected, it appears in the table of unconfigured devices on the Manage > Devices page and is categorized as New under the Management Status table header.
  1. Select the check box for the AP, and then choose Update > Advanced > Update Country.
  2. On the Update Country Code page, choose the appropriate country code from the drop-down list, and then click Upload.

The AP330 and AP350 802.11n wireless access points are designed for greater throughput and range, and can also be configured as routers.

The AP330 and AP350 provide dual concurrent 802.11b/g/n and 802.11a/n radios for 3x3:3 MIMO antenna configurations. When you enable 802.11n high-throughput options such as wide-channel mode (40-MHz channels), A-MPDU and A-MSDU packet aggregation, short guard interval, and MCS23 data rates, these models can provide a PHY data rate of up to 450 Mbps per radio. The AP330 has internal antennas, and the AP350 uses detachable external antennas. Both models have dual 10/100/1000 Ethernet ports for link aggregation or link redundancy. They can accept power from an 802.3af or 802.3at standard PoE (power over Ethernet) power injector or from an AC/DC power adapter connected to a 100-240 VAC input power source.

For more information about Extreme Networks APs in general, see "Introduction to Extreme APs"

For information about connecting your AP to the network, best-practices, and troubleshooting, see "Basic Troubleshooting for New Devices".

For compliance information for these devices, see http://www.aerohive.com/support/tech-docs-and-online-training.

Install the AP330 and AP350

Using the mounting plate and track clip, you can mount the AP330 or AP350 to the tracks of a dropped ceiling grid. Using just the mounting plate, you can mount the AP to any surface that can support its weight (AP330: 1.5 lb., 0.6 kg; AP350: 2.38 lb., 1.08 kg).The following sections describe these installation methods.

Component Descriptions

Hardware Specifications

The following specifications describe the physical features and hardware components, the power adapter and PoE electrical requirements, and the temperature and humidity ranges in which the devices can operate.


Cloud Terms of ServiceEvaluation AgreementData Privacy and Protection

Copyright ©  Extreme Networks, Inc. 6480 Via Del Oro, San Jose CA, 95119 USA